Router Configuration in CLI mood

I take course in CCNA provide by RUET. This course have four semister. I am now in first semister. In my lab i have learned configure the router in the CLI mood. So i want to share it with you…..

 

Now there is some code:

Router>enable 
Router#configure terminal 

//now we are going to put the ip address of the firsteathernet0/0

Router(config)#int

Router(config)#interface fa
Router(config)#interface fastEthernet0/0
Router(config-if)#ip add
Router(config-if)#ip address 172.16.1.254 255.255.255.0

//ip address and subnet mask that you want to configure

//now we are going to put the ip address of the serial port0/0:

Router(config)#interface serial2/0
Router(config-if)#ip add
Router(config-if)#ip address 172.16.3.1 255.255.255.0

##in the same way we can put the value of firsteathernet0/0, serial port 0/0 of other router conected to it…….

//now we are going to keep the router passward protecteed:


//To change hostname
Router(config)#hostname CCNA
CCNA(config)#line co
CCNA(config)#line console 0
CCNA(config-line)#pass
CCNA(config-line)#password cisco
CCNA(config-line)#log
CCNA(config-line)#login  

// now the enable password:

Router(config)#hos
Router(config)#hostname CCNA
CCNA(config)#enable password cisco
CCNA(config-line)#login 

// now the enable Telnet:

Router(config)#line vty 0 4

Router(config)#password class

Router(config)#exit

//Now we can configure Router from the host by enable telnet.

Advertisements